36 Elwyndene Road, March, PE15 9BL
Tel: 01354 652302, Mob: 07769 621620
12 VOLT DC POWER SUPPLY
2 AMP(includes a free adaptor for easy connection) £10.00
5 AMP - £20.00
(includes a free adaptor for easy connection)
2 x AAA Battery Holder with cover and on/off switch - £1.50
4 x AA Battery Holder with cover and on/off switch - £1.75
9 Volt battery clip - 50p
DC Power Distribution Board.
14 No Positive and Negative Terminals (Especially for those who don’t like to solder). The input power can be connected either by wires, a 2.1mm DC plug or a 2.5mm DC plug, the input terminal will handle up to 15 Amps, the board can be used for DC voltages up to 24vDC & DCC. (The board can be used with higher voltages, however the resister should be removed to disable the LED)
The LED will show Green if the Polarity is correct,Red if the Polarity is reversed by mistake
Price - £12.00
1 AMP (includes a free adaptor for easy connection) £6.50
3 VOLT DC POWER SUPPLY
1 AMP (includes a free adaptor for easy connection) £6.99
Fully adjustable DC to DC Voltage Step Down Module.
Output current:Rated current is 2A
Factory preset at 3 volts which saves having to solder resistors to 3 volt LEDs.
Fully adjustable DC to DC Voltage Step Down Module with LED Display.
SWITCHABLE DISTRIBUTION BOARD. The Input is via a 2.5mm DC socket or screw terminal block and can be any DC voltage up to 48v or a DCC voltage. There is a Main ON/OFF switch behind the Input terminal Block which isolates both the Positive and Negative Input feeds. The Input then passes through a 5 Amp fuse to feed the outputs and light the 'ON' LED. The ON Led is Tricolour so will indicate that the input is +- DC (Green), if connected the wrong way around -+ (Red) or DCC (Orange). This LED is after the fuse so will go out if the fuse blows.
The board has 6 individually switched outputs, each output can accept a load of up to 3 Amps and has an ON LED indicator.
Each Output has an ON/OFF switch which isolates both the Positive & Negative lines or in the case of DCC both lines. The LED is Green for ON or not illuminated for OFF.
The output at the far right of the board is a switched output directly from the main switch.
The Board has 4 fixing holes of 4mm so will accept screws or plastic PCB pillars.
This Distribution Board can be used for controlling individual lighting circuits on your layout, or controlling power to sections of the layout.
Length:120mm x Width: 32mm x Height: 26mm
9 volt PP3 Battery Holder with on / off switch
£2.50. Suitable for the 12v LEDs, or the 12v LED strips if you don’t want to use a 12v DC power supply.
DC/DCC Power Distribution Board.
A DC/DCC Power Distribution Board - if you are not into soldering. There is a set of Input Terminals and a set of extension terminals for the next Distribution Board. The output consists of 18 Positive terminals and 18 negative terminals. The board has a Power ON indicator, which is also a polatity indicator - Green is the correct polarity, Red is incorrect, & Orange is DCC. There are 6 fixing positions. Each board has a position to record the voltage, and the board No. The boards can be used for any voltage up to 48vDC, and upto 15 Amps per terminal. There is a printable record sheet on the web site to record terminal and wire colours & detinations