36 Elwyndene Road, March, PE15 9BL
Tel: 01354 652302, Mob: 07769 621620
Pair of OO Scale Level Crossing Lights
These will not flash automatically unless you use one of the BLOCKSignalling Level Crossing Modules below. £15.00
Manually switched Pair of Level Crossing lights with alternating flasher module and switch. Wiring diagram included. £24.99
Please note you will need a 12v DC regulated (smoothed) supply to operate the module. Outputs on the back of train controllers are not smoothed and the module is unlikely to work if using these. You can switch the amber light on, then the two red alternating flashing lights
BLOCKSignalling Level Crossing Controller LCS2-CA for Common Anode
Operates Level Crossing Lights Triggered by Infra-Red Sensor. Automatically operates up to four sets of level crossing warning signs with yellow and red leds.
Detects the presence of trains using an infra-red sensor located beneath the track.
When a train is detected, the yellow led is lit, then the two red leds light alternately.
Automatically switches off after a set number of cycles.
Fully configurable to alter the duration and flash rate of the leds.
Support for continental lights sequences.You can program it to skip past the first part of the sequence, where only the steady yellow light is shown and go straight to the flashing red LEDs. .This Level Crossing Simulator detects the presence of trains by bouncing invisible Infra-Red (IR) light off the underside of the rolling stock, and detecting the light reflected back. When a train is detected, it runs a built-in program to simulate the operation of UK or continental level crossings.
Illuminated Level Crossing Warning Sign (3 volt LED with resistor supplied for 12v supply). £3.50
BLOCKSignalling Level Crossing Controller LCS4-CA for Common Anode
Level Crossing Module with Real Sound
Uses an infra-red sensor to detect a train passing (can also be triggered by reed relay, push -button, switch, or simply supplying power to the module)
Automatically operates lights and sounder when triggered
Module reproduces a preselected sound clip from 18 possible choices (gongs, sounders, bells, Yodalarm, etc)
At the same time, the conventional light sequence of a single yellow light, followed by alternating red flashing lights commences
Automatically stops the sounder after 10 seconds
The module is fully programmable to adjust the flash rate, duration of the sequence, and so on
BLOCKSignalling Level Crossing Controller LCS5-CA for Common Anode
Fully Flexible Controller with Servo Motors for Barriers or Gates
Automatically detects trains using an infra-red sensor mounted below the track bed
Operates attached yellow and red leds on level crossing signs (not included)
Operates two servos (included) for connection to barriers or gates
Once train has cleared the sensor, the barriers return to their start positions automatically
Built-in programs to cover most UK crossing style
BLOCKSignalling Level Crossing Controller LCS6 - CA for Common Anode
Fully Flexible Controller with Sound and Servo Motors for Barriers or Gates
Plays one selected sound from a choice of 18 pre-recorded levels crossing sounds from around the world
Built-in programs to cover most UK crossing styles
Fully programmable to suit the modeller's requirements to replicate crossings from around the world
Pair of Level Crossing Signals. NON-FLASHING - Lights stay on constant (however you can use flasher module below if alternating flashing required. 12 v DC - £7.99. You can use either the alternating flasher module below with a switch if you want to turn them on and off, or you can use the Block Signalling modules above for common anode signals to automatically detect the train.
Alternating Flasher Module for level crossing signals. 12v input. £10.00. Assembled in England.